|
Gleco Trap 64 (C-097-004)
Gleco Trap 19 (C-097-005)
|
Gleco Trap
The Gleco Trap provides you with an economical plumbing trap that
is easily installed and maintained.
The Gleco Trap is connected
below the sink and collects solids in a bottle, which has a fill line.
When the solids reach the fill line, the trap is drained through a valve,
the bottle is exchanged with a replacement bottle, the valve shut and the
trap is back in service.
Bottle exchange is rapid
and done without the need of tools. Most of all, there is no mess
and less chance of water spillage.
2 Complete
Packages to choose from:
All Complete Packages come with the following materials to aid with
installation.
-
(1)
Extra Bottle with Lid
-
(1)
1-1/2" x 8" sink tailpiece
-
(1)
1-1/2" trap tailpiece
-
(2)
1-1/2" slip-joint washers
-
(4)
1-1/2" slip-joint nuts
-
(1)
1-1/2" flat washer
-
(1)
Extra O-Ring
-
Complete
instructions.
The Gleco Trap is Uniform
Plumbing Code (UPC) approved and can easily be installed in commercial or
residential buildings.
Key
Benefits of The Gleco Trap:
-
Adapts
easily to existing plumbing, wherever there is a p-trap.
-
Smaller
bottle means less odors created or emitted from the trap.
-
Translucent
bottle enables you to see the contents of the trap at any time.
-
Fill
line easily and quickly shows when the trap needs to be serviced.
-
Drain
valve eliminates spillage by allowing all the water above the
bottle to be drained prior to removal.
-
Replacing
the bottle takes less than 2 minutes, from start to finish, with
no tools, no spills, and no contact with the solids inside The Gleco
Trap.
|
|
|
Measure
This Distance:
The space requirements indicate the distance from the middle of
the drain pipe (that typically goes into the wall) to the floor
(height to allow bottle). |
 |
|
